DM 9000 and DM 9001
Two powerful, cost effective, shears which have the ability to accurately
cut PCB laminates, plastics up to 2.00mm thick and aluminium up to 1.5mm.
An important feature of these shears is safety. Free access to the cutting
area is prevented by heavy Perspex shielding extending along both sides
of the blade. A safety latch is fitted to the pivot to prevent operation
without it first being released. For positional accuracy the cutting bed
is fitted with a rule which is recessed to assist in securing the PCB
or sheeting whilst cutting is in progress.
The DM9000 has a cutting capacity of 203mm (8") and is extremely compact
with an overall height of only 575mm and a footprint of 335 X 140mm. It
has a cutting bed of 110mm wide from the blade although wider material
can be cut.
The larger DM9001 will cut materials up to 305mm (12") and has a height
of 670mm and a footprint of 440 x 245mm. It has a larger cutting bed 225mm
wide from the blade although once again wider material can be cut.
18" and 25" Shears
Two bench top shears suitable for cutting printed circuit board laminates, thin metal sheet and aluminium (1.5/2.0mm) or plastic labels / front panel materials. On lowering the operating handle, a spring loaded clamp is activated which holds the material securely during cutting, thus enabling cuts to be made with a mini-mum of effort. These shears are composed of an epoxy powder coated cast aluminium frame fitted with hardened and ground steel blades. The Model 45 has a clear acrylic front safety guard to protect the operator, whilst at the same time making it possible to see the blades so that the material to be cut can be aligned accurately. The Model 45 (illustrated) has an 18" cutting capacity and the DM525 25". Both have imperial and metric edge scales and fully adjustable front and back stops for batch work.
Model 45 18” Shear
DM 525 25” Shear
ES420 Corner Rounder
An inexpensive invaluable tool to meet the demand for a quick corner rounding facility for plastic/metal labels and front panels. The table is effectively split into two halves, each containing 90 degree stops, in the angle of each is a hardened radius of either 6mm or 4mm. The punch has been ground to simultaneously marry both of these rounds when driven down by the cam actioned handle. The material to be rounded is slid from the left or right hand side positively into the stops, to leave an overhang which is sheared through by the punch to leave a clean corner of either 6mm or 4mm radius. It should be noted that material originally cut out of square will result in an unbalanced round being removed. The table support column is mounted on a 5" X 5" steel plate with screw holes for bench fixing, although this will probably be unnecessary for most users. Overall height with handle upright 8" (205mm) and weight 1.2Kg.
