Roller Tinning Machine
Bench mounting roller tinning machine with 12" roller width. The solder tank is constructed from high grade stainless steel, suspended from a linkage mechanism.
This allows it to be lowered easily from the coating roller for access and general maintenance.
The two 1200 watt heaters ensure a fast heat up time, while the electronic temperature control system ensures
that operating temperatures are accurately maintained. The top pressure roller can be raised and lowered by a
single lever eccentric mechanism which enables it to be returned to the pre-set position without the need for
resetting. Additional features include digital temperature display, thumb wheel temperature setting and motor/
temperature interlock to prevent the motor being switched on while the solder is solid. The machines are
fitted with stainless steel covers which provide complete protection for the operator but allow quick and easy
access to the tank for replenishing salts and solder.
Specifications:
| IGP-305 | |
| Max board width | 305mm (12") |
| Max board thickness | 12mm |
| Solder bath capacity | 12kg |
| Heat up time (ambient to 240°C) | 20 mins (approx) |
| temperature control | +/- 2°C |
| Throughput speed | 0-10 metres/min |
| Electrics | 220-240V, 50Hz 1ph |
| Dimensions (mm) |
850L x 330D x 490H |
Roller Tin Consumables(lead based solder for permitted applications)
Solder
1 KG bars of 60/40 solder for roller tinning and 63/37 solder for wave soldering
machines.
Cover Salts
For use with roller tinning and soldering equipment. Cover salts are sprinkled
onto the surface of molten solder to prevent dross formation and oxidisation.
Supplied ready to use in 5KG containers.
Water Based Flux
A low residue roller tinning flux suitable for manual or automatic application.
Supplied ready for use in 5 or 10 litre containers.
Lead Free Roller Tin Consumables
For machines sold by Mega 2007 onwards
Lead Free Solder
For use with our latest design of Roller Tinning machines we offer Lead Free
Solder which has a 3% Silver content. To aid melting it is supplied as small
metal nuggets of approximately 2cm in size. Packed in 5kg containers.
Cover Salts
For use with roller tinning and soldering equipment. Cover salts are sprinkled
onto the surface of molten solder to prevent dross formation and oxidisation.
Supplied ready to use in 5kg containers.
Lead Free Flux
Specifically formulated for use with our Lead Free Solder. Supplied ready for
use in 5 litre containers.
PCB Board Dryer
This
stainless steel bench top PCB drying machine dries wet circuit boards through
a series of squeegee towelling rollers and a heated air knife.
The unit consists of four pairs of squeegee towelling rollers, the first pair
rotate in a shallow water tank with a
water level detector, this helps to capillary water trapped in the drilled holes.
The second and third pairs of rollers remove excess moisture before the circuit
board enters the heat zone where the high output blower air knife removes moisture
from both surfaces of the board and from inside the holes. The board then exits
through the last pair of rollers completely dry.
The electronic control module allows the operator the choice of two heat settings
with variable feed rates, thus giving optimum drying rates. The unit has an
automatic over-run switch which operates the wet squeegee rollers at maximum
speed for approximately ten minutes, with the heaters on, to part dry the rollers
for future use.
Maximum panel width: 610mm (24")
Motor speed: 0-5 metres/Min
